Card image

Software Products

New Model Construction Tools in UDEC

UDEC

Easy Model Stress Initiation (GUI/GIIC)

  • Topographic in-situ stress initialization - specify stress gradient - allows you to start out close to equilibrium with the fewest number of blocks or zones or risking artificially activating/shearing more shallow joints by using an initial average in-situ stress value.
  • Automatic stress initialization permits you to define stress at a point directly (e.g., in-situ stress measurement) to define stresses for the entire model (in-situ and boundary commands).

Block Generation (GUI/GIIC) Block Generation (GUI/GIIC)

Built-in automatic block generation commands to create bricks (left) and asymmetric Voronoi blocks (default Voronoi with 1:1 ratio, top right, compared to asymmetric Voronoi at a 1:3 ratio, bottom right).

Geometry Logic

The geometry logic allows the user to create, import, and export geometric data. These data can be used to interact with the model in a variety of ways. The data can be used as a filter with the range logic, and as a visualization aid with plotting. FISH extra variables and group names may be assigned to geometric data. FISH may be used to create and manipulate the data. The geometric data are organized into geometric sets, which are named collections of nodes, edges, and polygons. The geometry import command is used to import geometric data from a file that can be of type STL, DXF, or the Itasca geometry format.

Import DXFs (GUI/GIIC)

Using the Geometry logic, you can now import and use DXF files for UDEC model construction with automatic conversion of geometry into crack commands. DXFs are required to be watertight and of good quality. Some interactive DXF clean-up tools are available in the GIIC. You can see the workflow in the following diagram.

Enhanced Ground Support

In addition to improved visualization (GUI) for structural elements, a rock support database, including fully grouted bolts, end-anchor bolts, Swellex bolts, and split-set bolts (GIIC) is included. More examples for replicating manufacturer pull-test results have also been included (GUI/GIIC) to aid with model calibration.

SOFTWARE STORE
Software Support
UDEC Updates
Dernières Nouvelles
  • Itasca has announced the release of FLAC2D v9 Itasca has announced the release of FLAC2D v9, revolutionizing the way we analyze and predict...
    En savoir plus
  • 6th Itasca Symposium on Applied Numerical Modeling The next Itasca Symposium will take place June 3 - 6, 2024, in Toronto, Canada....
    En savoir plus
  • Itasca International Inc. announces the Selection of its New CEO Itasca International Inc. announces the nomination of its new CEO ...
    En savoir plus