Card image

Software Products

GExtract

Griddle

GExtract, previously “G_NMExtract”, allows extracting parts of surface meshes based on user-specified criteria. Surface meshes in actual engineering projects, in particular geological structures, can be very complex and there is often a need to extract (or separate) parts of the meshes, either to remove them or to assign specific properties in preparation for volume meshing. GExtract has five different modes of operation to assist with this.

  1. Single surface option extracts a surface using selected mesh face, specified break-angle, and non-manifold edge break flag.
  2. All surfaces option extracts all possible manifold sub-meshes from selected surface meshes based on a break-angle.
  3. Boundary faces extracts only those faces that are attached to naked edges (e.g, mesh boundaries).
  4. Non-manifold faces extracts only those faces that are attached to non-manifold edges if any are present in the mesh.
  5. Surfaces within solids extracts pieces of meshes that are located within a specified close volume solid (e.g., a box, cylinder, etc.) After the operation completes, extracted mesh pieces are selected so it is easier for the user to do other operations with them (e.g., hide, delete, move, remesh, etc.)
An example of single surface extraction with a break-angle of 10-degrees where “Break at non-manifold edges” is enabled. If this is disabled, the entire length of the pillar face would be selected.
The result of extracting AllSurfaces from a single, non-manifold, conformal mesh (some internal meshes are not visible) using a 60-degree break-angle.
The result of extracting the boundary faces of two intersecting meshes.
The result of extracting faces attached to the non-manifold edge of a single (combined) mesh.
Process of extraction of mesh faces located within a solid by using GExtract’s SurfacesWithinSolid mode.

New in GExtract

  • Extract multiple meshes at once based on angle and non-manifold intersections (“Mesh Explode”).
  • Extract all boundary faces.
  • Extract all non-manifold faces (i.e., faces along non-manifold intersections).
  • Extract sub-meshes within a user defined solid.
Order
Software Support
Latest News
  • Itasca has announced the release of FLAC2D v9 Itasca has announced the release of FLAC2D v9, revolutionizing the way we analyze and predict...
    Read More
  • 6th Itasca Symposium on Applied Numerical Modeling The next Itasca Symposium will take place June 3 - 6, 2024, in Toronto, Canada....
    Read More
  • Itasca International Inc. announces the Selection of its New CEO Itasca International Inc. announces the Selection of its New CEO ...
    Read More